The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
Please follow the new instructions to uninstall and reinstall your dongle drivers:
1. Download the latest driverhereand save + extract the ZIP file directly under C:\temp.
2. Remove the dongle.
3. Open the command prompt (run cmd as administrator) and start the file with the following options (see Image 01):
"C:\temp\haspdinst.exe -fr -kp –purge" (omit quotation marks; uninstall the drivers).
4. If the procedure was successful, please restart your computer with:
5. Now, install the driver in the console as follows: "C:\temp\haspdinst.exe –i"
6. Plug in the dongle again.
You can download the current dongle driver with the installation dialog box (GUI) using the following link:
For installation via the command prompt (console), it is possible to use the following installation package:
In FE‑LTB, only the loads that act directly on the set of members are transferred.
If the loads are introduced into a continuous member by connecting components, they have to be added manually.
Examples include hall frames with crane runway consoles, 3D halls with purlin roofs, multi-span frames, and so on.
For example, if a force acts on a cantilever that does not belong to a continuous member, this loading must be added manually. It is then necessary to shift the load into the node and apply the overturning moment.